Walnut wood-grain steel garage door with a row of top windows
  • Torsion and Extension
  • Replaced in Matched Pairs
  • ROC #310144

Garage Door Spring Repair in Gilbert, AZ

Heard a loud bang and now the door won't lift? We weigh your door, replace springs in matched pairs, and test the balance before we leave.

A person answers after hours, and after-hours and weekend work carries a $250 call fee.

  • ROC #310144
  • Licensed, Bonded & Insured
  • Women-Owned Family Business
  • 90-Day Labor Warranty
  • Google Rated
Garage door interior with track and opener in Gilbert, AZ

If your door came down hard and made a bang like a gunshot, if it now lifts about a foot and stops, or if it will not lift by hand at all, you are on the right page. That is a spring, and it is the single most common call we get.

The Spec Is the Job

Our Gilbert page explains why this town breaks springs on a schedule: a place where six homes in ten went up after 2000 has whole streets on the same door, the same spring, and the same install date, and they reach the end together. That is the when.

This page is about the what, because a spring is not a part you pick off a shelf.

A spring is specified to a door, and four numbers decide it.

  • The door's actual weight.
  • The drum size.
  • The track radius.
  • And the height of the opening.

Get any of them wrong, and the door is either too heavy to lift by hand, or it climbs on its own, and the opener spends the rest of its life fighting a counterbalance that was never right.

  1. Weight is the one that gets guessed. Two doors of identical dimensions can differ by fifty pounds depending on whether they are insulated, whether they carry glass, and how many sections have been replaced over the years. A Gilbert tract door that has had one section swapped after a reversing car is no longer the door the builder hung.

  2. So we weigh it. On the floor, disconnected, on a scale. It takes a few minutes, and it is the difference between a spring that lasts its rating and one that does not.

  3. What this means for you on the phone: we cannot give you a firm number without knowing the door, and anyone who does is quoting a category rather than your garage. What we can tell you is what moves the number, and that is set out below.

Garage door interior with track and opener in Gilbert, AZSpring repair in Gilbert, AZ

What We Do on a Gilbert Spring Call

Garage door interior with track and opener in Gilbert, AZ
  1. We weigh the door rather than guess it. A spring is matched to the door's actual weight, not to its size, and that weight is not something a tape measure gives you. Getting this wrong gives you a door that is either too heavy to lift by hand or drifts up on its own, and an opener doing work it was not built for.

  2. We replace in matched pairs. On a two-spring door, when one fails, the other is the same age and has done the same work. Replacing one leaves you with a mismatched pair and a second visit inside a year.

  3. We check the rest of the counterbalance while we are in there. Cables, drums, the center bearing, the end bearing plates. A spring that failed hard can take a cable with it, and finding that on the same visit saves you a second one.

  4. We test the balance before we leave. With the opener disconnected, a correctly balanced door should stay put at waist height rather than drop or climb. That is the check that tells us the new spring is right, and it is the step most often skipped.

  5. And we talk to you about cycle life before we order anything, because that is the one decision that is genuinely yours on this job.

The One Choice Worth Making

You are replacing a wear item. The only real question is how long you want the next one to last.

We supply 10,000-cycle through 100,000-cycle springs. Higher-cycle springs are wound from heavier wire at a larger diameter, so they do the same work under less stress and last proportionally longer. They are custom ordered rather than stocked, so there is a lead time, and on a door that is currently unusable, that trade-off matters.

The Gilbert version of this question. The median Gilbert house was built in 2003, which means most of these decisions are being made by a second or third owner who is not planning to leave. If you are one of them, and the garage is how your household actually gets into the house, buy the cycles. If the house is going on the market in two years, do not.

One thing we are clear about. The higher-cycle spring is a longer-lasting part. It is not a safer one. A correctly sized 10,000-cycle spring on a correctly balanced door is a perfectly good repair, and we will say so.

What We Do Not Do on This Call

  1. A spring somebody has already tried to adjust gets undone before it gets replaced, and so does a repair made with a length of chain and a bolt. If we find one, we tell you what putting it right involves.

  2. The motor on an opener without photo eyes remains untouched. Federal rules require secondary entrapment protection on residential garage door operators manufactured on or after January 1, 1993, satisfied by a photo eye, an edge sensor, an inherent door sensor, or an equivalent device. Our own rule is simpler: if there are no photo eyes, we do not touch the motor. We will still do the spring, and we will provide you with a quote for a replacement head. In Gilbert, it is a rare find. It does happen.

  3. Outside our scope entirely: electrical work; jamb, framing, drywall, or stucco work; locks or rekeying; garage screens; and mobile or manufactured homes. Home warranty dispatch is currently on hold.

There is no minimum job.

What Affects the Price of a Gilbert Spring Job

A spring job has four variables and the combination decides it. Here they are, so the quote you get from anyone makes sense.

The service call is $85, covering a 22-point inspection and the first half hour of labor. After hours and on weekends it is $250 instead. A quote over the phone is free.

  1. How many springs the door carries. The post-2000 tract houses we work on in Gilbert have two-car and three-car garages, so the doors we quote here usually run two torsion springs. Some lighter single doors run one. Two springs is two parts where a single door has one, and the same labor.

  2. The door's actual weight. An insulated steel door with glass sections weighs meaningfully more than a plain single-skin door of the same size, and it needs a heavier spring. This is why we weigh rather than assume, and it is why a quote given over the phone without a make and model is a guess.

  3. The cycle rating you choose. This is covered under The One Choice Worth Making. It is the one variable in your hands.

  4. What else the failure took with it. A spring that lets go under load can fray a cable, mark a drum or knock the door out of true. Sometimes nothing else is wrong. Sometimes the cable is the reason you are calling and the spring is fine.

The order of operations is fixed. We look, we tell you what it is, we give you the number, and then we do the work. Nothing comes apart before you know what the job costs.

If Your Spring Has Just Gone

  1. Stop using the door.

    On a broken spring, the opener is trying to lift the door's full weight with a motor sized for a counterbalanced one, and a few attempts will finish the opener off.

  2. Leave the emergency release alone while the door is up.

    The release disconnects the door from the opener. On a working spring, that is fine. On a broken one, the opener carriage is the only thing holding the door, and releasing it drops the door.

  3. If the door is down, leave it down.

    If it is partly up, get people and cars clear and then leave it.

  4. A broken torsion spring is usually visible as a gap of an inch or two in the coil on the bar above the opening.

    Confirming it is our job. Tell us what you heard and what the door is doing now.

What Customers Say

"Great service. The repair man was on time found what the problem was replace the springs gave me a fair price and also windy, clean and very polite. Would recommend up to anyone who needs garage door service."
Joseph SmithSeptember 2025
See this review on Google

Gilbert Spring FAQ

How long should a garage door spring last in Gilbert?

On a 10,000-cycle spring at four openings a day, a little under seven years. Households that use the garage as the main entrance to the house go through cycles faster and experience shorter lifespans. Higher-cycle springs last proportionally longer.

One spring broke. Do I have to replace both?

On a two-spring door we recommend it, and it is what we quote. The second spring is the same age and has done the same work, so replacing one buys you a mismatched pair and a second call.

My house is from 2004, and this is the first spring failure. Is that late?

It is about three times what the cycle arithmetic predicts, which means the door has been opening closer to once a day than four times a day. It happens, and it is good news. It also means the spring is well past the point where a second failure would be a surprise.

Can I replace a torsion spring myself?

A torsion spring stores a large amount of energy and requires winding bars and the correct wind count to fit safely. It is a trade job, and we will leave it there.

Why does my whole street seem to be having this all at once?

Because the street was built all at once. Same doors, same springs, same install date, so they reach the end of their service life together.

Do you work on extension springs too?

Yes, though they are uncommon on Gilbert's housing. If you have them, we check for a containment cable running through the spring, because a spring that fails without one does not stay where it was.

Where We Work

Garage door repair and service across the Phoenix metro:

See the full service area

Tell us the year the house was built and what you heard.

On a house built in the boom years, those two things usually tell us what we are walking into before we get there. Office hours are Monday to Friday, 7:00 a.m. to 3:00 p.m.

Garage door interior with track and opener in Gilbert, AZ