Garage Door Repair in Glendale, AZ
Broken springs, snapped cables, off-track doors and openers fixed across Glendale, on torsion and extension spring doors, including doors we did not install.
A quote over the phone is free. A service call is $85, which covers a 22-point inspection and the first half hour of labor. After hours and on weekends, it is $250.
- ROC #310144
- Licensed, Bonded & Insured
- Women-Owned Family Business
- 22-Point Inspection
- Google Rated

Glendale homes have both kinds of garage door spring, torsion and extension, and each breaks differently. Tell us which you have and we can usually narrow the repair on the phone.
The Two Systems, and Why It Matters Which One You Have
A garage door has to be counterbalanced, or nothing can lift it. There are two ways of doing that on a sectional door, and we treat them as two different jobs because they are.
Torsion. A steel shaft runs horizontally above the opening with one or two springs wound onto it. Cables run from drums at each end of that shaft down to the bottom brackets. Everything sits in one place, the load is shared by a single assembly, and we can adjust the tension in a controlled way.
Extension. Two long springs run horizontally along the upper tracks, one on each side, stretching as the door descends. There is no shaft. Each side works independently, which means it can go out of balance.
Our Glendale page explains why both systems are still here in numbers.
Garage door repair in Glendale, AZHow We Tell, and How You Can
Our garage door repair page has the quick version of this test. Here is what the quick version misses, and it is worth two minutes before you call.
Stand inside with the door closed and look up. If there is a steel bar running across the wall above the door with a spring or two wrapped around it, that is torsion. If instead you see two long springs running back from the top of the door along the ceiling line, one above each track, that is extension. If a spring has already broken, look from the doorway and leave it at that.
If you see neither, look for a one-piece door that tilts out as it opens instead of rolling up in sections. Those use their own arrangement, and we service them too.
Two things make this harder than it sounds, and they are worth knowing before you go out there. A finished ceiling can completely hide a torsion shaft, so the absence of visible springs is not proof of anything. And some doors carry both a torsion shaft and the remains of an old extension system still bolted to the track from a conversion that was never fully stripped. If what you see does not match either description cleanly, that is useful information and not a failure to look properly, and it is worth saying so on the phone.
Tell us which when you call. With that in hand, the call can narrow the job rather than circle it.
What Changes, System by System
| Torsion | Extension | |
|---|---|---|
| What fails | A spring, a cable at the drum, a bearing, a drum set screw working loose | A spring, a pulley, a cable, or a bottom bracket; and the failure is usually one-sided |
| How the door behaves first | It gets heavy and may drop, because both sides lose lift at once | It goes crooked, because one side still has its lift and the other does not |
| What is on the estimate | The specification of what we fit, so the record exists for next time | The same, plus whether the containment cables are present and sound |
| The safety question | The tension sits in one assembly, and we release it in a controlled order | A failed extension spring under tension is loose in the garage, which is the reason containment cables exist |
| Whether the door can stay as it is | Normally yes, and we repair it in place | Normally yes. Where you convert it instead, our spring conversion page sets out what that involves |
That specification matters more on an older door than on a newer one, because the next person to work on it will otherwise be guessing the same way we had to.
The One Thing We Will Not Do on Either System
We do not touch the motor on an opener with no photo eyes. It is a hard refusal rather than a preference, and it applies to both spring families, because it is about the opener and not the door. Our Glendale page explains the rule behind it.
Everything else on the door is ours, within the scope set out below.
What We Actually Establish Before Quoting
Five things, and we would rather spend the time than guess at any of them.
Which system, confirmed on sight, and not assumed from what the last house on the street had.
What the door weighs and how it behaves by hand, with the opener disconnected. We weigh the door and measure the old spring, so the new one is specified for your door, not matched by eye.
Whether the failure is the whole story. A cable that has jumped its drum and reseated under load leaves marks worth reading, and on extension springs a single failed side has usually been loading the other one for a while.
Whether the parts are current. Usually they are. Where a part is no longer made, you hear that on the visit and not after we have ordered it.
And the condition of the track itself, which matters differently on the two systems. Extension springs hang off the horizontal track and pull against it every cycle, so on that family the track is load-bearing in a way it simply is not on a torsion door. A track that has spread at a joint or pulled at a bracket is not a cosmetic finding there. It is part of the counterbalance, and we inspect it as such.
Every visit includes a balance check with the opener disconnected and a safety reverse test before we leave, on either spring family.
Scope on This Job
Ours: the door, its track, its counterbalance in either family, its cables, drums, pulleys and brackets, its hardware, its safety circuit, and the opener.
Outside our scope: locks, handles, and rekeying, which are locksmiths' jobs. A new outlet or circuit for an opener, which is an electrician's job before ours. Jambs, framing, drywall and stucco, where the door is ours, and the building around it is not. Garage screens and window retrofits into an existing door. Mobile and manufactured homes. The motor on an opener with no photo eyes. Home warranty dispatch, which is on hold at present.
There is no minimum job. Where we judge a door unsafe to run, we tag it out and say so rather than leave it in service. Our labor carries a 90-day warranty, and manufacturer parts warranties are honored. If our work does not hold, we come back and make it right.
Glendale Garage Door Repair FAQ
Do you work on extension springs, or only torsion?
Both, and on Wayne Dalton TorqueMaster as well.
My door goes up crooked. Is that the springs?
Often, on extension springs. It is the classic sign there because the two sides are independent. On torsion, it points somewhere else, usually a cable or a drum. Either way, it is worth dealing with before the door comes off its track.
Can I convert from extension to torsion?
It depends on the headroom above the opening and on having something solid to mount the shaft to. Our spring conversion page sets out what the job involves, and we will tell you whether your opening will take it.
Do you work on doors you did not install?
Yes, whoever made them. On a door that came with no paperwork, the first thing we settle is which counterbalance it has, and everything else follows from that.
Is there anything on the door you will not touch?
The motor on an opener with no photo eyes. The door itself is still ours, within the scope above, and a replacement head is something we can quote, so the choice stays yours. That is the only no on the door's own mechanism.
What does the $85 buy, and does it stand if I decide not to go ahead?
It covers the visit and the 22-point inspection, including the part of that inspection that determines which counterbalance you have, plus the first half hour of labor. It stands either way, and it is not credited against work you do go ahead with. Our what to expect page lists every fee.
One of my springs broke, and the door still works. Can I leave it?
On extension springs, that means one side is carrying what two were built to carry, and the opener is carrying the difference. It is not a situation to leave for long. On a two-spring torsion door, the surviving spring has done the same work as the one that failed, so we quote replacing both.
What Customers Say
"Great company to work with."
Where We Work
Garage door repair and service across the Phoenix metro:
- Mesa,
- Gilbert,
- Chandler,
- Tempe,
- Scottsdale,
- Phoenix,
- Queen Creek,
- Apache Junction,
- Glendale,
- Peoria,
- Ahwatukee,
- Fountain Hills and
- Paradise Valley.
Look up before you call. It is the fact that narrows everything else.
Tell us whether you see a bar across the wall or two springs along the ceiling, and a phone quote is free from there.


