Garage Door Repair in Chandler, AZ
A quote over the phone is free. A service call for a failed door is $85, covering the 22-point inspection and the first half hour of labor. After hours and on weekends, it is $250. A technician coming out to look and quote is $35.
Know what's wrong? Go straight to Chandler spring repair, opener repair, emergency repair, new doors or opener installation.
- ROC #310144
- Licensed, Bonded & Insured
- Women-Owned Family Business
- 22-Point Inspection
- Google Rated

Garage doors have been this family's trade in this valley since 1997 without a break, and we are still family-owned and operated. Chandler is inside the area we cover, for repairs and for installation alike.
What the inspection covers, when a figure arrives, what carries a deposit, and where the job stops are all written down below.
What a Service Call Covers, and How Far It Reaches
Where the work reaches, and the one place that boundary moves. Repair and service run across the Phoenix metro and no further. New door installation is the exception: that work travels outside the valley.
The inspection covers the entire door, not the complaint. Twenty-two items in four areas: the door and the hardware holding it to the opening, the counterbalance, the two seal lines, and the opener with its force settings and safety circuit. A call about a keypad that has stopped responding still produces a reading in all four areas. The technician who ran the list reports what he found, and the decision on any of it is yours.
Two of the twenty-two are tests, and they carry no conditions. He disconnects the opener and lifts the door by hand to read spring tension and balance, because a counterbalance that has drifted cannot be read off a powered door. And he tests the automatic reverse before leaving on any door with an opener. Those two happen on every visit.
The last item is lubrication. Clopay notes that lubricant wears off faster in dusty conditions, so we lube the hinges, rollers and bearings while we're there.
Garage door repair in Chandler, AZThe Order a Figure Arrives In
The look comes before the number. A technician drives out, inspects the door, diagnoses it, and works the estimate up from what he found in the garage. The complete inspection and diagnosis occur during that visit, so any cracked section or tired cable is visible at the time of service. A quote over the phone is free, and it is a quote: we do not diagnose a door nobody has looked at.
We write the estimate and email it to you before any work starts. Approval is the step between the figure and the work, and what sits on the estimate is what the technician found in the garage.
What is paid when. An ordinary repair requires no upfront payment. A part that has to be special-ordered carries a 50 percent deposit at the time of order, and so does a made-to-order door. That deposit is non-refundable. We carry the common parts. Where something has to come in, the wait is on the supplier, and we tell you that wait before anybody orders it.
Chandler Garage Door Repair FAQ
Is this inspection the same thing as a tune-up?
It is the same list of twenty-two items. The difference is the booking: on a service call, the inspection happens alongside a repair on a door that has already failed, and the tune-up is the same list booked on its own, before anything has failed, which is what our garage door tune-up page is for.
The door still runs, but something looks wrong. Is that a service call or a quote visit?
The $85 service call is for a failed door. A technician coming out to look and price something, with no work done that day, is the $35 visit. The $85 is not credited against an approved repair, and declining the estimate does not remove it. Say which visit you want when you book, and ask which fee applies before anyone is dispatched.
Is there a minimum job?
There is no minimum job or invoice of any kind. One roller is a job. So is a remote that has stopped pairing.
Can I buy the part at the counter instead?
Yes. The office has a walk-in parts counter, Monday to Friday from 7:00 a.m. to 3:00 p.m., no appointment needed, and any component of a garage door can be sold over the counter upon request. It is the one route on this page that involves no visit at all. DASMA's TDS #167 warning block accompanies a counter sale: a door with a broken spring should not be operated until the spring is replaced, and no one should try to remove, repair, or adjust springs or any door parts or mounting surfaces.
If I sell the house, does the warranty go with it?
Our 90-day labor warranty does not transfer with the sale of a home. The manufacturer's warranty on the parts does go with the house, and what it covers depends on which product was bought.
What Stands Behind the Work
The license. ROC #310144, licensed, bonded, and insured, covering residential and commercial work.
The labor warranty. Ninety days on our labor, and manufacturer warranties on the parts honored as the maker wrote them.
The boundary on openers does not move for anybody. Secondary entrapment protection has been required on residential garage door operators manufactured on or after January 1, 1993. The federal rule allows a photo eye, an edge sensor, an inherent door sensor, or an equivalent device, and the trade settled on photo eyes. Our own rule is firmer: no photo eyes; we do not touch the motor. We still service the door itself and quote you a replacement head.
The firm and the phone. We are a women-owned family business. Our office runs Monday to Friday, 7:00 a.m. to 3:00 p.m. A live person answers our phone after hours, never voicemail. Saturday is not a routine service day and must be scheduled; a weekend or after-hours call incurs the $250 fee. What we will not give you is an arrival window.
What the estimate carries that a web page cannot. Where a specification matters, it goes in writing on your estimate: the gauge of a strut, the cycle rating of the spring being installed, the roller going on the door. The technician writes those for your door.
What the City of Chandler Publishes
Chandler's permit manual exempts ordinary repairs that don't cut walls, beams or exits, and it doesn't mention garage doors.
Chandler Development Services confirms what a specific job needs, and changing the size of an opening is the case to ask about.
What This Visit Does Not Cover
Both sides of this boundary are written down. Here is ours, and here is where it stops.
Ours on a repair call: the door itself, whatever brand and whatever age, on doors and openers we did not install, and that includes one-piece tilt-up doors, extension springs and Wayne Dalton TorqueMaster counterbalances. Sections and hinges. Rollers and the track they run in. Brackets and bearing plates. Torsion and extension counterbalances, with their shafts, drums and lift cables. The seals, top and bottom. The opener with its rail, trolley, settings and safety circuit. The balance check and the safety reverse test.
Outside our scope: locks, handles, and rekeying, which are locksmith work. A new outlet or circuit for an opener, which is an electrician's job before ours. Jambs, framing, drywall and stucco after an impact, where the door is ours, and the building around the opening is not. Garage screens and window retrofits. Mobile and manufactured homes. The motor on an opener with no photo eyes. Home warranty dispatch, which is on hold at present.
Where We Work
Garage door repair and service across the Phoenix metro:
- Mesa,
- Gilbert,
- Chandler,
- Tempe,
- Scottsdale,
- Phoenix,
- Queen Creek,
- Apache Junction,
- Glendale,
- Peoria,
- Ahwatukee,
- Fountain Hills and
- Paradise Valley.
Everything above is settled before anyone drives out.
What is left is your door, and the technician reads that in the garage. Book the visit when the terms on this page suit you, or ask at the counter if the part is all you want.


