Garage door installed on an Arizona home in Phoenix, AZ
  • 22-Point Inspection
  • Any Brand
  • Doors We Did Not Install
  • ROC #310144

Garage Door Tune-Up in Phoenix, AZ

A 22-point inspection, balance and safety-reverse tests, and lubrication to the manufacturer's spec, with a written record of every point emailed to you. Any brand, including doors we did not install.

A quote over the phone is free. A service call on a door that has failed is $85, covering the 22-point inspection and the first half hour of labor. After hours and on weekends, it is $250. If you want a technician to come and quote first, that visit is $35.

  • ROC #310144
  • Licensed, Bonded & Insured
  • Women-Owned Family Business
  • 90-Day Labor Warranty
  • Google Rated
Garage door installed on an Arizona home in Phoenix, AZ

A tune-up is usually booked on a door we did not sell, which determines what the first visit is for. It produces a baseline: what is on the door, how it is running today, and which parts are partway through wearing out. None of that was written down anywhere before we came.

On a Door We Did Not Sell, the First Visit Is Record-Keeping

A garage door does not come with a service history. Whatever paperwork the original install generated is long gone, if it ever reached the house at all, and if a previous owner had an opener swapped or a section replaced, nobody kept a note of what came off. The door is the only source there is.

So the technician reads it and writes it out. Three kinds of information go on that baseline:

  • What is on the door: Counterbalance family, section profile, hardware, opener generation, and whether the safety systems the opener should have are present and connected.

  • How it is running today: Where in the travel the effort changes when the door is lifted by hand, whether it holds where it is left, and what it sounds like.

  • What is partway through wearing out: A cable with a strand standing proud at the drum. A bearing with play in it. A bottom seal that no longer meets the floor.

The third kind needs a date beside it. Wear has a direction, and one reading cannot show it. So the findings get written out and emailed, including the points that passed, which is the half of the paperwork that reads like filler and is not.

Garage door installed on an Arizona home in Phoenix, AZGarage door tune-up in Phoenix, AZ

Where the Baseline Has to Come From

Our Phoenix page carries the housing figures and makes the point this page stands on: a Phoenix address does not tell you what is on the door. Its age, its hardware, and whatever a previous owner changed are facts you can only collect at the door.

On a repair call, that matters less than you would expect: the fault narrows the field by itself. A tune-up has no fault to narrow anything with. So in Phoenix every line of the baseline comes off the door, and none of it off the street or the decade the house was built in.

The Twenty-Two Points, and What Gets Written Against Them

The inspection is twenty-two numbered points, written by the owner of this company and worked in her order. It was not assembled from anybody's advertisement. The sequence runs door, counterbalance, seals, opener, then the safety systems last, so the safety tests run on a door that has already been through everything else.

  1. The door and the hardware it runs on: Panels and sections. Hinges. Rollers. Vertical tracks. Horizontal tracks. Track and jamb brackets. Flag brackets and bearing plates.

  2. The counterbalance, where the weight is: Torsion or extension springs, for wear and rust. Spring tension and door balance. The torsion shaft. The drums. The lift cables. Bottom fixtures and cable attachment points. Top fixtures and roller brackets. Center and end bearings.

  3. The seals: Weather seal and bottom astragal. Perimeter weatherstripping.

  4. The opener: Opener mounts and rail. Opener force and travel limits.

  5. Then the safety systems: Photo-eye sensors. The automatic reverse test. And a closing pass over manual operation, overall noise, lubrication and a final safety check.

  6. Two items on that list are tests, and they happen whatever else the visit turns up: The balance check happens on every visit, including the ones booked for something else. The safety reverse is tested before we leave.

  7. The full numbered twenty-two, and the case against the point counts this market advertises, are on our tune-up page.

Phoenix Tune-Up FAQ

My door works fine. Is there anything on the list to find?

Two things worth knowing are invisible while a door is working: whether the counterbalance is still carrying it, and whether the reverse systems still function. Both are on the list. What we will not do is tell you from here that your door is fine, because nobody has looked at it.

Do you tune up doors you did not install?

Yes, any brand and any age, including doors whose original installer is long gone. A door like that is exactly the one the written baseline exists for, because nothing about it is on file anywhere.

Does Phoenix dust mean the door needs lubricating more often?

The one manufacturer-published statement is Clopay's: lubricate every three to six months, and in dusty conditions the lubricant may not last as long and may need to be reapplied more frequently. A dry bearing is a short-lived bearing.

Will I be told what passed and what failed?

Yes, in writing. A page of points with nothing recorded against most of them is the comparison you own for next time.

What happens if the inspection finds something serious?

Then it stops being a tune-up and becomes a conversation with an estimate at the end. A broken spring, a cracked or separating section, and an opener with no photo eyes are findings, and each gets explained before anything else happens. A door we consider unsafe to operate gets tagged out.

What the Baseline Is Worth the Next Time Somebody Looks

A finding on its own is a note. The same finding with an earlier one behind it is a decision, and that is what a first visit cannot give you.

  • A bearing that sounded dry is a line on a page. The same bearing with play in it now is a part to change, and the second reading is what makes the first one useful.

  • Balance is the clearest case. A door that held where it was put and now settles when it is let go has said something about its springs that no single visit could. Without the first reading, a door that drifts is just a door that drifts.

  • The baseline belongs to you. The findings are emailed, and so is the estimate, before any work starts, and you keep both whether you approve anything or not. Nothing here commits you to a second visit, and nothing commits us to chasing you for one. Call when you want the door looked at again, and whoever does it, us or anyone else you hire, will have a record to work from.

Which Published Fee Applies, and Which Does Not

Three visit fees are published on this site, plus a free quote by phone, and a tune-up sits beside them rather than inside one, so it is worth being exact.

  • $85 is a service call on a door that has failed. It covers the 22-point inspection and the first half hour of labor, so on a failed door the inspection is already in what you are paying.

  • $250 replaces that $85 when somebody comes out after hours or on the weekend.

  • $35 is the visit where a technician comes to look and quote instead of to work.

  • A quote over the phone is free, and on a tune-up, that is the call to make first.

A tune-up on a door that is still working is not a failure call, so no price for one is published here. We are not going to invent a figure to fill the gap. Ask on the phone, and you will be told before anybody is dispatched.

Anything the inspection turns up is quoted separately. The estimate is written and emailed before work starts, so the figure reaches you ahead of the work. A special-order part carries a 50% deposit. There is no minimum job.

Scope on This Visit

  1. Ours: the 22-point inspection on any brand and any age of residential door, including doors and openers we did not install in the first place. Lubrication to the manufacturer's specification. Hardware tightened. The balance check and the safety reverse test.

  2. Not part of a routine tune-up: adjusting spring tension as a matter of course. A balance check that fails is a finding and a conversation, because adding tension to a tired spring spends what is left of it.

  3. Outside our scope: locks, handles and rekeying. Any new outlet or circuit, which is an electrician's job before ours. Jambs, framing, drywall and stucco. Garage screens and window retrofits. Mobile and manufactured homes. The motor on an opener with no photo eyes. Home warranty dispatch, on hold at present.

  4. If we get it wrong, we make it right. Ninety days on our labor, and every manufacturer's parts warranty honored.

What Customers Say

"Joani and the team at Quality Overhead Door were quick to respond and amazing to work with. ... They replaced my overhead garage door opener and improved the balance and smooth operation of my existing door."
Marco CeglieDecember 2025

Where We Work

Garage door repair and service across the Phoenix metro:

See the full service area

Book your Phoenix tune-up.

Tell us when the door was last serviced, if you know, and we will schedule the 22-point visit.

Garage door installed on an Arizona home in Phoenix, AZ