Arched stained wood garage door set in a stacked stone surround
  • Both Sides Read Together
  • Cables and Drums Checked
  • Specification on Your Estimate
  • ROC #310144

Garage Door Spring Repair in Phoenix, AZ

A quote over the phone is free. A service call is $85, which covers a 22-point inspection and the first half hour of labor. After hours and on weekends, it is $250.

  • ROC #310144
  • Licensed, Bonded & Insured
  • Women-Owned Family Business
  • 22-Point Inspection
  • Google Rated
Garage door installed on an Arizona home in Phoenix, AZ

A torsion spring fails all at once, and you will know when it does. There is a bang, the door becomes something you cannot lift, and the opener either refuses to move it or tries and gives up. The part that fails is simple. What is not simple is working out what the door needed in the first place, because the only thing that ever recorded that is the spring now lying in two pieces.

What a Break Actually Does

A torsion spring stores the energy it takes to lift your door. When it lets go, that energy leaves in a fraction of a second and the door stops being counterbalanced.

The door becomes its own weight. A sectional residential door is heavy enough that lifting it by hand is a two-person job at best, and that is why the first instruction for any broken spring is to leave it alone.

The opener inherits a load it was never specified for. An opener is sized to move a balanced door, not to lift an unbalanced one. If somebody has operated the door since the break, the opener has been doing work that belongs to the springs.

And the cables stop being under even tension. That is the quiet part. A cable that goes slack and then takes load unevenly can leave the drum, and a cable off its drum is a separate job sitting on top of the first one.

On an extension-spring door, a break usually drops one side, so the door lifts crooked. Without a containment cable running through the spring, the broken piece can fly across the garage, and we raise that on the estimate whether or not you asked.

Garage door installed on an Arizona home in Phoenix, AZSpring repair in Phoenix, AZ

The Broken Spring Is the Only Record of What the Door Needed

This is the part that surprises people, and it is why a spring job is more than just fetching a matching part.

  • A spring has to be specified for your door, not matched by eye. Two springs that look alike can differ in wire size and length enough to leave the door heavy or drifting. The specification has to come from somewhere, and that is what this page is about.

  • Almost nothing about your door's correct counterbalance is written down anywhere you can reach. There is rarely a plate on the jamb listing it, and the installer did not leave paperwork with the wire size. The installed spring is the record, and its wire diameter, inside diameter, and length together constitute the specification.

  • Reading that record after a failure is reading a damaged source. A broken spring can be measured, and we do measure it. But a spring in service has been working, and a spring that has snapped has lost its geometry at the break. So the measurement gets us close, and it still has to be checked against what the door actually weighs and how it actually behaves.

  • There is also a more common problem than a damaged record: a record that was never right. A spring can be correctly matched to the door that was hung and wrong for the door that is there now. An insulated section installed after a collision, a strut added later, a door repainted more than once: each one is undramatic, and all of them change what the springs are being asked to hold.

Why the Record Is Worse in Phoenix

Elsewhere, a damaged record is survivable, because an ambiguous measurement can be checked against what doors on that street usually take. Here there is no "doors like this one usually take" to check against: the door next to yours may have nothing in common with it.

So we support the measurement with the door itself. We weigh it, we balance it by hand, and we read the pair together before we wind anything.

The Rest of the Assembly, After a Break

A spring does not live alone on the shaft. After a failure, six things are worth reading before anything is wound.

  1. The other spring, where there are two. It has just absorbed the moment its partner stopped helping.

  2. The cables. Fraying shows first at the drum and at the bottom bracket, and a cable that has gone slack and snatched is a different condition from one that has simply aged.

  3. The drums and their set screws. A cable that has come off and been put back on without the drum being checked is a job that comes back.

  4. The bearings and the shaft. A bearing that has been running dry makes a noise that people attribute to the door rather than to the shaft it turns on.

  5. The bottom brackets. They carry the cable; they are under tension whenever the door is down, and they are the one part of this assembly that should never be loosened by anybody who is not doing it deliberately.

  6. And what the door did while it was broken. If it was operated on a failed spring, the opener's gear, the top section, and the lift points have all taken loads they are not designed for. We look for that specifically, because it is the difference between a spring job and its consequences.

Tell us if it was used after the bang. People almost always say no at first and then remember they moved the car, and it is genuinely not something we mind hearing. It changes what we check, and a fault found now has not had a month to do further damage.

One Spring or Both

We quote the pair. On a two-spring door both springs have done the same number of cycles, so the survivor is usually close to failing too. The table below is the narrow case where doing only the broken one is defensible, and what you are accepting if you do.

Replacing the broken one onlyReplacing the pair
When it is reasonableThe pair is genuinely young, the surviving spring measures and behaves as specified, and the break looks like a defect rather than wearThe pair has shared its service life, or the surviving spring no longer matches the specification the door needs
What you are acceptingTwo springs of different ages and different remaining life on one shaftA door whose counterbalance is matched and dated from one point in time
What we check firstWhether the survivor measures to the same wire, inside diameter and length as the one that failedWhether we can specify the pair correctly for the door as it stands now, not as it was hung
What goes on the estimateThe specification of the spring we fit, and that we assessed the second one and left itThe specification of both, and why we took the pair together

We put the specification of whatever we fit on the estimate, because a standard spring is not a thing, and because the next person to work on this door needs the record it did not have.

Scope on This Job

  1. Ours: the springs, the shaft, the cones, the drums, the cables, the bearings and the brackets they run in, plus the balance and the safety circuit afterward.

  2. Outside our scope: locks, handles and rekeying. A new outlet or circuit for an opener, which is an electrician's job before ours. Jambs, framing, drywall and stucco. Garage screens and window retrofits into an existing door. Mobile and manufactured homes. The motor on an opener with no photo eyes. Home warranty dispatch, which is on hold at present.

There is no minimum job, and we will tag out a door we consider unsafe to operate.

What We Do on a Spring Call

Garage door installed on an Arizona home in Phoenix, AZ

We take the door off the opener first, so we are reading a door and not something being driven. We measure the broken spring and the survivor against it, where there is one. We weigh the door. Then we check the cables, drums, bearings, and brackets while the tension is off, because that is the only sensible time anybody can check them.

Then we wind the replacement, balance the door by hand with the opener still disconnected, and reconnect the opener last. The safety reverse is tested before we leave on every visit, and the balance check is part of every visit, including one that had nothing to do with the springs when it was booked. Our labor carries a 90-day warranty, and the spring manufacturer's warranty is honored. If you want springs that last longer, ask about high-cycle springs.

Phoenix Spring Repair FAQ

My spring broke. Can I still use the door?

Please do not. The door is no longer counterbalanced, so it is heavy in a genuinely dangerous way, and operating it transfers the load to the opener and the top section.

Can I just get the same spring again?

That is the goal, and it is not automatic, because the broken spring records what was installed rather than what the door needs. If the two differ, installing the same part again reproduces the original mistake.

Do both springs have to be replaced?

We recommend and quote the pair on a two-spring door. The narrow exception, a young pair where the survivor still measures to spec, is set out above, along with what goes on your estimate either way.

Why does the door get weighed if the spring can be measured?

Because the measurement tells us what was on the door and the weight tells us what the door is now. Added insulation, a replaced section, or several coats of paint all change the second without changing the first.

My door has two springs, and only one broke. Was the other one faulty?

Usually not. One failing first is ordinary and not a sign that the pair was wrong.

The house is from the 1990s, but the garage door looks older. Which one tells you what the spring should be?

Neither, on its own. A door can be newer or older than the house it sits on, and in Phoenix that is common enough that we stopped inferring either way. We weigh the door.

Do you work on extension springs, or only torsion?

Both, including Wayne Dalton TorqueMaster. Our garage door repair page covers TorqueMaster specifically.

Will you tell me what it costs before you start?

Yes. A quote over the phone is free. On the visit, the $85 service call covers the 22-point inspection, and we do nothing beyond it until you have agreed to the estimate. Our "What to Expect" page sets out each fee and what it buys.

What Customers Say

"Had an issue that several gagrgae door companies failed to remedy."
Dean MesquiteJanuary 2026

Where We Work

Garage door repair and service across the Phoenix metro:

See the full service area

If it has gone, leave it down and call.

A quote over the phone is free. We will tell you what we need to establish during the visit and why we look at the second spring, either way.

Garage door installed on an Arizona home in Phoenix, AZ